Please enable JavaScript.
Coggle requires JavaScript to display documents.
Process study. Existent bottle? - Coggle Diagram
Process study.
Existent bottle?
Yes?
Already produced in Plastipak?
Share the quality report information of the previous trial.
Share lessons learned and the reason for the new trial? What is the difference vs previous one?
Provide samples of the previous trial.
Start with the process from the previous trial - If produced in Brecht
Not produced but samples available from market / competitors.
Make an assessment of the market bottle.
Request 15 bottles for:
Top load.
Section weights.
Wall thickness measurement.
No?
Benchmark similar bottles from the supermarket or our portfolio.
Request bottle specifications to the customer.
Depending on the importance of the project, a support from the simulation team might be requested to confirm the target SW for the best mechanical performance.
Customer information
support:
Bottle specifications:
Top load.
Filling temperature.
Burst resistance.
In case not available, do an assessment to bottles with similar design in the market, similar volume and same material.
Process assumptions/requirements
Minimum target output.
1000 b/h/c - Sidel
1500 b/h/c - 1Blow
SprayPET - 800 b/h/c
Cooling temperature - 12C unless the bottles will be used for hot fill.
In case bottles were produced at Brecht in the past, start with a similar process depending on the reason of the need for a new trial.