Please enable JavaScript.
Coggle requires JavaScript to display documents.
The centre lathe - Coggle Diagram
The centre lathe
-
Chuck
-
-
-
The Chuck of the lathe is usually protected by cover, which must be placed down for the lathe to switch on.
-
-
centre
-
Second, each Line crosses the centre of the. Fires diameter. where the lines crossed will be the centre of the workpiece.
Clamps the work in the Chuck using the central carriage wheels. We bring that to over to the centre of the workpiece.
Loosen their two of climb and change the height of the tool using the adjustment screw. You may need to do this a few times. Tighten the Tool climb again.
lathe cutting tools.
Lathe tools are called single point cutting tools because only one edge removes the material from the workpiece.
-
-
-
4 jaw independent Chuck
-
allows for very precise Control, This truck type is used for holding round, square or a regular Shaped work.
-
