Please enable JavaScript.
Coggle requires JavaScript to display documents.
The Electrical Troubleshooting, cables - Coggle Diagram
The Electrical Troubleshooting
Step Process
Step 2
is
defining the problem area
entails the application
reasoning
defining the problem area
isolate the fault in the area.
This task will be easier if you possess a schematic diagram of the circuit
logic
Step 3
identifying possible causes
identify the problem areas
thinking of possible causes of the problem
It can be done by writing down the parts with possible causes to the fault in the circuit
.
Step 4
determine the most probable cause of the fault in the circuit
comparing the findings from visual observations with the identified problem areas
using this knowledge to determine the faulty component
step three will make it easier to pick out the most probable issue.
Defective components will show the following signs:
Signs of burning can be observed in light bulbs, fuses, switches
The final step involves testing and repairing the circuit.
Heat may cause failure in transformers, motor coils, and other devices with windings.
Adhesive bolts, screws should be checked; they often detach over time
Defective wiring should be checked.
Step 1
Observe the circuit
examination is carried out
The circuit is checked for visual indications of mechanical damage
loose components
strained wires
Careful observation is carried out to find faults in the circuit
IS
the process of solving a problem
troubleshooting is done when there is an electrical fault
