Please enable JavaScript.
Coggle requires JavaScript to display documents.
Lesson 6 - Coggle Diagram
Lesson 6
Dimensions
-
-
Dimensions lines, extension lines should not cross or overlap, dimensions must be placed outside the part
-
-
Tolerances
Bilateral tolerance
the term used when the tolerance zone is distributed from the target value or true profile in both directions.
-
-
-
Fits
Clearance Fit
Minimum shaft diameter is larger than the maximum hole diameter. Difference between the two diameters is the amount of interference
Interference Fit
Maximum shaft diameter is smaller than the minimum hole diameter. Difference between the two diameters is the amount of clearance
-