Please enable JavaScript.
Coggle requires JavaScript to display documents.
Dimensions, Tolerance and Assemblies - Coggle Diagram
Dimensions, Tolerance and Assemblies
DIMENSIONS
-
-
Chain Dimensioning
Only be use if the function of the object would not be affected by the accumulation of the tolerances
-
-
-
-
Dimensioning of Circle,Arc and Hole
A Circle is dimensioned by its diameter ,An Arc is dimensioned by its radius,Holes are located by their centerlines
-
Rules of Dimensioning
Dimensions should not be duplicated, i.e. same dimension should not be repeated on different views, or the same information need not be given in two different ways
-
Dimension lines, extension lines and object outlines should not cross or overlap
TOLERANCE
-
Types of Tolerance
Bilateral Tolerance
allowed to vary in two directions from the specified dimension. Both directions need not vary by the same amount.
-
-
-
-
Assembly Modelling
-
-
Types of Joint
-
Revolute Joint
Has a single rotational degree of freedom, much like a hinge.
-
-
-
-
-