Please enable JavaScript.
Coggle requires JavaScript to display documents.
Projector 3D Print - Coggle Diagram
Projector 3D Print
-
-
Hope to Accomplish
I believe that this "pod" that I am going to create will revolutionize my experience with my projector.
A protable, easy setup, projector holster to adjust height and angle.
My projector is a tad neglected due to the fact that it is too hard to set up the angles properly for a good width on a wall
I want to use it more, as it can provide a bigger screen than a TV for fun movies and has alot of potential.
-
-
-
Hope To Avoid
A small flimsy excuse of a holster for my prjector, in which the smaller pieces break off.