Please enable JavaScript.

Coggle requires JavaScript to display documents.

Beacon - Coggle Diagram

- - - - if Anything fault in the values shows the related Error with Indicating the LED's
  - - - check whether After OTA configuration
        Initialize with the Timer values
        set the force sending keep alive packet on startup
  - - - It will set the watchdog for every 1 second
    - - Beacon.cpp
        
        if(TimerSecond.IsTimeout())
        
        RF.Init();
        
        Initialize RF for sending Sync packet
        get and recalculate the RF power
        
        UnsyncedBroadcast(); calls if not synchronized with Base station
        
        this will send sync packet in all available channels
        
        if(SyncTask<TASK_CONDITION>())
        
        BeaconTxTask<TASK_FINALIZE>();
        stops beacon transmission if any going on
        
        SyncTask<TASK_INIT>();
        
        if(Flags.SyncedToBP)
        
        Set TimeOut for short search time
        
        not synced to Base station
        
        Set TimeOut for long search time
        
        RF.BeginRx(Configuration.GetBPChannel());
        
        set for listening at RF at given channel
        
        if(BeaconTxTask<TASK_CONDITION>())
        
        it will check whether synced to BP/not and Tx allowed/not
        
        Handle Zone beacon transmission
        
        set timer values for zone beacon transmission
        
        Handle Gate Beacon transmission
        
        Check for BC Gate Frames Transmission Start/End Time
        
        switch (BeaconState)
        
        case SEARCH_SYNC:
        
        verify all sync frames
        
        if(SyncTask<TASK_FINALIZE>())
        search for command in current second
        
        DownLinkTask<TASK_INIT>();
        
        else
        don't search for command in current second
        
        DownLinkTask<TASK_FINALIZE>();
        
        case SEARCH_COMMANDS:
        
        DownLinkTask();
        
        it will go into Rx mode and get commands from BP like change ID/channel
        
        case TRANSMIT_BEACON_FRAMES:
        
        BeaconTxTask();
        
        beacon packets formed and sent to BP over RF
        
        case IDLE:
        
        if(Flags.BeaconGateTxAllowed) it will set beacon state to TRANSMIT_BEACON_FRAMES
        
        if(UpLinkTask<TASK_CONDITION>())
        
        Stop the Beacon Transmission and check for any UPLINK Request / else Generate the Random Timeslot for UPLINK Transmission
    - - led blinking operation in continuous mode