Design and make a prototype for a key ring - Coggle Diagram
Design and make a prototype for a key ring
The colour is very important and should be bright
The shape is also very important because if the shape is wierd and wonderful it will attract mroe customers
It has to have some form of personalisation
It has to have a Museum logo
The materials have to be cheap
the materials have to be sturdy
Copper or iron for the metal
Cheap plastics such as acrylic, nylon or fiberglass
The gender of the target market. You can make it male or female orientated or unisex.
The age of the target market can also vary as an elderly person would like something different to someone who is middle aged or just entered adulthood.
The amount of money the target also matters as someone may want to look at the prices of the product before buying it.
As you are in a gift shop the price will be slightly higher than normal such as £5-10
The materials must be cheap.
It has to be big enough to be seen from about 10 -20 m away
It has to be smaller than 10 cm as it has to fit in a pocket
Something that can hold a photo
It has to be able to unhook keys
It have to be able to hold keys
The product must be strong as it will be used in a rough environment
I also have to be small enough to fit in a pocket as that is wear the product will be
The product has to be tough and able to withstand drops and falls
It should also be recylable so that when it is time to throw away then it be reused after being stripped for materials.
The materials that are used, if not recyclable must be biodegradable.
No open circuits for additional features
No sharp edges
No toxic finishes
Any other safety concerns have to be warned about with the product.