Please enable JavaScript.
Coggle requires JavaScript to display documents.
Too high permanent set after static compression (1.Liner thickness after…
Too high permanent set after static compression
1.Liner thickness after curing too high
not enough densified
1.3 Need liner compression before bonding to remove porosity
1.3.1 Try liner precompression on flat press
1.2 Need higher pressure during bonding step
1.2.2 Increase Silicone plug initial volume
1.2.3 Lower blank ID
1.2.1 Modify curing mold geometry (spacer/ closing method)
1.2.4/4.1Modify Curing cyle
1.2.4 optimise silicone casting method repeatbility
1.2.5 initial liner thickness not repeatble
1.2.5.1tighten tolerances
3.S2110 Liner from fenner not resistant enough
...
3.1Try another liner
3.1.1 S1910 LINER
...
4.Liner crosslinking cycle not optimized
2.Finishing operations weaken the liner
Honing impact
chamfer impact
Test method not repeatable enough
Impact of the temperature
Impact of the pre tribo testing