Please enable JavaScript.
Coggle requires JavaScript to display documents.
πΉπππππ πΊππππππ π«πππ https://www.youtubeβ¦
πΉπππππ πΊππππππ π«πππ
https://www.youtube.com/watch?v=84QcX-X7Z6A
π»ππ ππππππππ :
1) Using the wire wheel then connect it straight to the drill to remve all the dust at the shutter.
2) Spray the shutter.
π»ππ π°ππππππππππππ :
9) Slide the top section of the curtain behind the barrel from below and then up and over into a suitable position for fixing.
8) Insert the key into the unit and turn in the down to rotate the barrel.
7) Connect the motor wire to the key unit to a suitable power supply.
10) Fix the collars securely into place with the washers and nuts.
6) Fix the key unit to the wall.
11) Bend the bottom nylon cap and slide in the second section of curtain then bend the nylon cap back into position.
5) Secure the other side of the barrel ensuring it is perfectly horizontal with the aid of a spirit level.
12) Turn the key in the up or open direction to send the curtain almost to the top.
4) Move the barrel into position and fix the left hand side into the place with the nuts and bolts.
13) Fix them securely via the pre- drilled holes, ensuring that the countersunk boalts go to the inside.
3)Fit the both side hand support angle into position using appropriate fixings with drill machine.
14) Adjust the upper limit and lower limit until the perfect position.
15) Fit the manual override head into the position on the bottom of the motor.
1) Measure the curtain width without end caps and add 40mm to obtain the overall back of angle width.
16) Use the clip to secure it and hook in the manual override stick.
2) The back edge of the support angles need to be positioned to ensuring they are equal and vertical from the edge of the opening.
πΊππππππππ :
π΄ππππππππ πππ π΄ππππππππππ ππππ :
Washer and nuts
Set roller shutter door
Drill machine